34829-1-0115
Page 54
ACCENT LAMP LIGHT REPLACEMENT
DVTT ACCENT LAMP LIGHT REPLACEMENT
If in the event the lamp or lens needs to be replaced, follow the
instructions below:
1. Unplug the remote from the junction box or disconnect all power
to the fireplace.
2. Remove the 4 screws that secure the lens frame. This frame
retains the glass lens. The bulb can now be accessed.
IMPORTANT: Do not handle the lamp (bulb) with bare
fingers, protect with clean dry cloth.
NOTE: The lamp will pull straight out of the socket. When re-
installing, ensure integrity of gasket seal.
Replacement Bulbs
Replacement bulbs are available locally at most hardware, appliance
or building supply stores. Replace with a G9 (120V/25W) series
halogen bulb.
THE FIREBOX MUST BE SEALED.
Over-tightening the screws could break the lens.
"Light Leakage" from the upper area may be observed. The holes
in the lamp housing are necessary for ventilation and must not be
covered.
MOTO
R
COMM.
G
LIGH
TS
AU
X
FAN
120V EXTENSION
MODULE
JUNCTION BOX
Figure 63 - Accent Lamp Wiring
LAMP
GLASS
GASKET
BEZEL
Figure 64 - Accent Lamp Parts