![background image](http://html1.mh-extra.com/html/empire-comfort-systems/dvlt36fp92n-2/dvlt36fp92n-2_installation-instructions-and-owners-manual_2404085035.webp)
34829-1-0115
Page 35
DVTT42 LOG PLACEMENT
Before you begin: If you are installing logs into the DVTT42 model
then this fireplace is supplied with a set of 14 ceramic fiber logs. Do
not handle these logs with your bare hands. Always wear gloves to
prevent skin irritation from ceramic fibers. After handling logs, wash
your hands gently with soap and water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation of this
fireplace. Sooting and other problems may result if the logs are not
properly and firmly positioned in the fireplace.
1. Remove mesh screen if applicable.
2. Remove glass door from firebox.
3. Remove logs from bun.
4. Remove the plastic wire tie holding the grate to the burner.
Discard the plastic wire tie and set the grate aside.
5. Place liner into firebox.
6. Place log grate into firebox. The front bar will butt-up against
the burner.
7. Place the Right Ember Bed Chunk (A) between the right front
and right rear legs of the log grate and resting on the liner
bottom.
8. Place the Left Ember Bed Chunk (B) between the left front and
rear legs of the log grate and resting on the liner bottom.
9. Slide the Ember Bed Front (C) under the log grate. It will be
in front of the Left Ember Chunk (B) leaving an open space to
the right front of the log grate.
10. Place the Ember Bed Front Extension (D) next to the right of
the Ember Bed Front and under the log grate.
11. Place the Left Rear Log (E) on the rear bar of the log grate.
The slot and groove on the log will fit over the left two bars of
the log grate.
12. Place the Right Rear Log (F) against the back bar of the log
grate. The grooves on the log will fit over the two right bars of
the log grate.