![background image](http://html.mh-extra.com/html/empire-comfort-systems/dvcp36pp30n-1/dvcp36pp30n-1_installation-instructions-and-owners-manual_2404064032.webp)
36092-2-0316
Page 63
36092-2-0316
Page 62
INTERMITTENT PILOT ELECTRONIC SYSTEM OPERATING INSTRUCTIONS
5.25 VDC ELECTRONIC CONTROL VALVE
The electronic control valve system includes the ability to switch
the pilot from a standing pilot mode to an intermittent pilot mode.
•
IPI Mode
- In the Intermittent Pilot mode, when the
fireplace is turned ON, it will cause spark to the pilot,
light the pilot, then allow the burner to light. When the
fireplace is turned to OFF, both the burner and pilot will
be OFF.
•
CPI Mode
- In the Continuous Pilot mode, the pilot
remains ON continuously even when the burner is
turned OFF.
NOTICE
: A small toggle switch is located on the front of the
module tray that is used to switch from IPI (left) to the CPI (right).
See Figure 75.
When the fireplace is turned to ON, the electrical current will
energize a spark to the pilot igniter. Once the pilot sensor heats
up (after a few seconds), the valve will be energized, allowing
gas to flow to the burner.
1. Follow the SAFETY and LIGHTING INSTRUCTIONS for
Intermittent Pilot controls found in this manual, and on labels
found in the control compartment located in the lower cavity
of the fireplace.
2. During the heating season (or in power outage periods), it is
recommended that the pilot remain in the CPI (standing pilot
mode) to reduce cold start issues, and/or conserve battery
backup power during a power outage.
3. The gas valve has inlet and outlet pressure taps as shown in
Figure 75.
Refer to page 16 for gas pressure requirements.
NOTICE
:
The gas control has a manual HI/LO flame adjustment
knob (regulator) that allows you to increase or decrease the
height of the burner flame.
See Figure 75.
Rotate the HI/LO
knob counterclockwise to “HI” to increase the flame height, and
clockwise to “LO” to decrease the flame height.
OPTIONAL REMOTE CONTROLS
Optional remote controls are available for use with this fireplace.
It is recommended that the remote receiver be placed either in a
wall outlet box with extended wiring, on the fireplace hearth, or
in the control compartment area as far forward in the insert as
possible.
The placement options for the remote receiver are given to allow
flexibility, however battery life will be extended when the receiver
is placed in cooler areas.
To connect the remote receiver to the fireplace, first disconnect
the ON/OFF switch wires from the white and green wire
connectors and connect the wires from the remote receiver to the
green and white wire connectors. See Page 63.
Follow the instructions included with the remote control for
programming and other operational information.
Figure 75
INTERMITTENT PILOT ELECTRONIC SYSTEM WIRING DIAGRAM
If any of the original wire as supplied with this fireplace must
be replaced, it must be replaced with equivalent gauge and
temperature rated wire.
WARNING
Electrical Grounding Instructions
This module is equipped with a three-prong (grounding)
plug for your protection against shock hazard and should
be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong from this
plug.
CAUTION
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dangerous
operation.
CAUTION
Do not operate the fireplace with glass panel removed,
cracked or broken. Replacement of the panel should be
done by a licensed or qualified service person.
WARNING
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, personal injury
or loss of life. Installation and service must be performed
by a qualified installer, service agency or the gas supplier.
Verify proper operation after servicing.