Emotiva Fusion Flex, User Manual

Page: 17 / 26

Page 13
Fusion Flex Amplifier
Configuration
Operating Voltage
Verify that the EFusion Flex Amplifier is configured for the correct operating voltage for your area.
(Voltage is set via the AC Input switch on the rear panel of the Fusion Flex Amp).
Power Mode
The way in which the Fusion FLex Amplifier responds to the Trigger Input, audio signals, and the
front panel Standby switch is determined by the setting of the Power Mode switch (the small bat
switch on the rear panel below the speaker outputs, to the right of the Trigger and IR Inputs).
When the rear panel Power rocker switch is set to Off, the Fusion Flex Amp is powered completely
off and will not respond to any other control, switch setting, or input. In order for the Fusion Flex
Amp to operate as described below, the rear panel Power rocker switch must be set to On.
• When the Power Mode switch is set to On, the Fusion Flex Amp is controlled by the front
panel Standby switch, which toggles between Standby and operating (On) modes each time
it is pressed.
• When the Power Mode switch is set to Auto, the Fusion Flex Amp is controlled by audio input;
the Fusion Flex Amp switches On when there is audio signal present at any of the inputs (this
will occur even when audio arrives at an input which is not assigned as a source); the Fusion
Flex Amp will return to Standby mode about fifteen minutes after audio input signal is no
longer present.
• When the Power Mode is set to Off, the Fusion Flex Amp will switch On when a trigger signal
is received, and will return to Standby mode when the trigger signal is no longer present.
Remote Control
The Fusion Flex Amp responds to certain remote control commands (including the Power On
command) when in Standby mode. The rear panel Power rocker switch is a manual, mechanical
switch; when it is set to Off, the Fusion Flex Amp is powered completely off and will not respond
to any remote control commands. The remote control Power Off commands (and the Standby
button) return the Fusion Flex Amp to Standby, but do not remove all AC mains power (the
remote control receivers remain powered on).