Emotiva BASX MC1, User Manual

Page: 36 / 48

Page 30
BasX MC1 Cinema Processor
SETUP - ABOUT
This menu gives you access to a variety of information about the various firmware modules
currently installed on your MC1 and some of the devices connected to your MC1.
Software Update -
This option is used to update the firmware on your MC1.
Note: Firmware is updated by placing the firmware update file on a USB stick, formatted with a
standard FAT32 format, and inserting the stick into the rear panel Update USB port.
Firmware update may be initiated by either:
1. Inserting the USB stick containing the firmware update file into the rear panel Update port
while the MC1 is powered Off, then turning the MC1 On. At this point the MC1 will detect the
firmware file automatically and install it.
2. Inserting the USB stick containing the firmware file while the MC1 is powered On and then
selecting Software Update from this menu.
NOTE: The firmware update will take several minutes and will display a progress indicator.
DO NOT DISCONNECT POWER TO THE MC1 OR REMOVE THE STICK DURING THE UPDATE.
You will see a message when the update is completed, and your MC1 may return to either On
or Standby mode - depending on how the update was initiated. You will NOT be required to
update your MCA to factory defaults after most updates.
MCU Version, DSP Version, OSD Version -
These items display useful information about the
firmware modules installed on the MC1.
Bluetooth Name -
Displays the Bluetooth Name that will be associated with the MC1 when other
devices are paired with it. You MAY change the name that the MC1 displays to other Bluetooth
enabled devices.
Bluetooth MAC -
This item displays the network hardware address of the Bluetooth network
receiver inside the MC1.
TV Connect 1, TV Connect 2 -
This item displays some useful information about the HDMI
devices currently connected to the HDMI outputs of the MC1.