Documentation Version 1.2.6
Documentation Version 1.2.6
/ 41
Appendix
9°) Insert the TF card into the eMotronic drive.
Press to the click
(the card is locked)
10°) Press the «Reset» button located on the lower metal part to take into account the new firmware.
11°) In the TF card, make sure that the «firmware.bin» file is changed to «firmware.cur».
12°) On the eMotronic board, between the USB connector and the auto-leveling sensor connector, make sure that:
- LED1 remains on
- LED2 and LED3 flash continuously
- LED4 remains on
LED1
LED2
LED3
LED4
LEDs
From there, the eMotronic card should be recognized by the Device Manager and the contents of the TF card should be displayed in the Files Explo-
rer. It will then only remain to realize again the calibration of the 3D printer.
Summary of Contents for MicroDelta Rework
