Documentation Version 1.2.6
Documentation Version 1.2.6
/ 17
PREPARATION
Charging filament
2°) Disengage the extruder
Disengage by pushing
here
3°) Insert the filament in the extruder’s inlet and
push it as far as possible
inlet
4°) If you encounter a hard point while inserting the filament,
engage the extruder and turn the drive wheel until the filament
gets to the nozzle, melted filament should start coming out
Drive
wheel
Filament tip
Filament
1°) Cut the tip of the filament with a certain angle
to make its insertion in the extruder easier
5°) Tighten the spring strongly by turning the knurled screw.
Note: if the knurled screw is not tight enough, the filament will be badly driven
Knurled screw
Summary of Contents for MicroDelta Rework
