30
Appendix
Documentation Version 1.2.6
1°)
Relieve the spring pressure completely by unscrewing the horizontal knurled screw of the eMostruder
2°)
In the Repetier-Host software, with the 3D printer connected and turned on, from the «Manual control» tab, ask for a target temperature dedi-
cated to the used filament and wait until it is reached.
3°)
If some filament is already engaged in the machine, remove it and cut it off to an healthy base not marked by the driving wheel.
(with the end of the new filament bevelled in the winding direction of the spool or sample provided)
Spring filament pressure adjustment (eMostruder)
Objective :
adjust the pressure exerted by the spring on the filament so that the drive is optimal and does not cause abnormalities.
Description :
depending on the type of filament used (PLA, G-FIL, ABS, etc.) and especially its hardness, it will be necessary to adjust the spring
pressure so that the driving wheel does not mark the filament too much and does not block in its passage to the nozzle. This method ensures that
the filament drive is operational while exerting pressure on the filament as low as possible.
195
Summary of Contents for MicroDelta Rework
