Emos ZY1937, Manual, Page: 2 / 32

2
GB
LASER PROJECTOR
Indoor and Outdoor Laser Decorative Lighting
Important warning:
The laser decorative light works only in the dark.
Note:
Attention : To prevent harmful laser radiation, do not use the product for purposes it was not designed for according to the manu-
facturer. Do not shine directly into the eyes or the face. Do not open the product under any circumstances. Do not connect to power
supply while the product is still in packaging. We do not provide warranty for damage caused by incorrect use. The manufacturer
bears responsibility only for damage caused during correct use.
Safety & installation:
Before using the device, read the instruction manual carefully! Follow the safety instructions when putting the device into
operation; otherwise, there could be a risk of injury to persons or damage to objects. Follow all safety instructions to avoid
damage due to incorrect use! Keep the instruction manual for later use. If you pass the product on to another person, also
provide them with the instruction manual.
Important safety warnings:
1. Read and follow all safety instructions and all instructions listed on the product or enclosed with it.
2. Do not remove the information table.
3. The product may be used by children over 18 years of age. Persons with reduced physical, sensory or mental abilities may
use the product only if they understand the contents of the instruction manual, will follow its instructions, and are aware
of the dangers associated with the use of the product. Children must not play with the device. Children must not clean
the device on their own; they must be supervised by a person older than 18 when doing so.
4. Mounting and electrical installation of the device must be done always with adherence to the relevant directives and
standards, including fire-prevention regulations, after consulting a professional.
5. If used in the vicinity of a swimming pool, make sure the product is at least 3 metres away from the pool; do not use the
device in the bathroom.
6. Warning: Danger of injury by electrical current. When used outside, plug the product only into protected electrical sockets
(with cover). If such a socket is not available, contact a professional to ensure proper installation. Make sure the power
supply unit and the cable do not prevent the closing of the socket.
7. Warning: Do not connect the product to electrical sockets which are only watertight when closed.
8. Do not disassemble the network cable; doing so creates the risk of injury by electrical current or creates a fire hazard.
9. To reduce the risk of injury by electrical current, only unplug the product from the socket when the product is turned off.
10. Do not use the product if damaged.
Warning: If there is an air corridor within 20 km, do not point the device in that direction. If there is an airfield within 20 km of
the place of use, adjust the angle of the device so that the laser lights do not shine to the sky.
Instructions for use:
1. Take all parts of the product out of the box. If you are not using the product, store it in the box.
2. Choose a suitable spot for the device: there should be no obstacle between the device and the projection surface, so that
the light can be projected without disruption.
Distance Projection surface
3 m 20 m2
6 m 90 m2
8 m 140 m2
10 m 200 m2
12 m 280 m2
14 m 360 m2
3. Screw the head onto the stake (fig. 1). Check that the head is directed at the chosen
surface. Push the sharp tip of the stake completely into the ground on the chosen spot.
If it is difficult to push the stake in, you can hammer the stake in gently using a rubber
hammer. Never put pressure on the product.
4. Rotate the head on the stake in clockwise direction.
5. Loosen the nut, insert plastic pin into the projector head and rotate in the required
direction.
Fig. 1