2
Technical Data Sheet
1 kWp-Stand Alone Solar Power Plant-Configuration SRTP/2N- ANERT
System Descri ption
Solar Photovoltaic (PV) Modules generates DC electricity in proportion to the amount of sunlight available
and generates more power on a clear day when the sun is at a normal angle to modules. The power
generated from the PV module will be supplied to the Load through the Solar PCU (Charge Controller
+ Inverter) which will convert DC Power to AC power, monitor and control the charging and discharging
of battery.
EMMVEE-1kWp Stand Alone Solar PV Power Plant is designed with the following
major components
•
Solar Photovoltaic Module – 1000 Wp
•
Solar PUC ( MPPT Charge Cont Inverter)-1000 W
•
Solar Low Maintenance Lead acid Battery-7200 Wh (24 Volts, 300Ah @ C
10
•
Solar Module Mounting Structure. • Copper Cable.
Technical Specifications
Solar Photovoltaic Module
PV Module nominal Power
250 Wp (4Nos)
Maximum Power Point Voltage (Vmp)
30.06 Volts
Maximum Power Point Current (Imp)
8.32 Amps
Open Circuit Voltage (Voc)
36.78 Volts
Short Circuit Current (Isc)
8.75 Amps
Solar Power Conduction Unit (MPPT Charge Con Inverter )
System Voltage
24 Volts
Inverter Nominal Power
1000 W 1 Phase 230V AC 50Hz out put
Inverter Efficiency
>80%
Charge Controller Technology
MPPT (Maximum Power Point Tracking)
PV Protection
Reverse flow Protection from Battery to PV Module
Electronic Protection for
Low battery, Short circuit & Over Load Protection at the input & output
Working Technology
The PCU takes solar power as First priority to supply the load and charge battery, if there is NO
solar power available, then it will take form the Battery as second priority to support the load, in
case there is NO solar and also Battery goes below the set value then as last priority it will draw
Grid power to supply the load and also to charge the battery to pre set value.
System Usage
•
Maximum allowed continuous load at any point of time 1000 W
•
75% of Rated capacity of the battery shall be between fully charged & load Cutoff
condition. This is equal to 5400Wh.
•
The Energy used from the battery can be re-charged during clear sunny day.
•
However the amount of charging varies with the Sunshine condition during the day
Area required for Solar PV Modules installation: 15 M
2
²
Warranty
Complete System is warranted for 60 Months from the date of installation of the system / invoice
(EMMVEE warrantee terms shall be applicable).
*Specifications are subject to change without notice
Solar Low Maintenance Lead acid battery
Nominal Voltage
24 Volts
Nominal Capacity
300 Ah @C10
% of Battery Capacity- Fully Charged-Load cutoff Condition
75%
Load v/s System Back-up time based on
Watt Hours/day
