EMKO EAOM-72F, Manual, Page: 12 / 48

12
During installation into a metal panel, care should be taken to avoid injury from
metal burrs which might be present. The equipment can loosen from vibration
and become dislodged if installation parts are not properly tightened. These
precautions for the safety of the person who does the panel mounting.
1.
2.
3.
4.
Before mounting the device in your panel, make sure that the cut-out is of the right size
Make sure that the diameter of the holes are of the right size and coordinate of the holes are
true.
Check front panel gasket position
Insert the device through the cut-out. If the mounting screws are on the unit, put out them
before inserting the unit to the panel.
2.5 Panel Mounting
c
1
3
2
2 2
2
4
The unit is designed for panel mounting.
Insert the unit in the panel cut-out from
the front side.
Insert the fixings through the mounting
holes and tighten the fixing screws to
secure the unit against the panel.
1.
2.
Fixing is done by four screw fixings.
2.6 Installation Fixing Screws
Montage of the unit to a system must be done with it’s own fixing screws. Do not do the
montage of the device with inappropriate fixing screws. Be sure that device will not fall
while doing the montage.
During mechanical installation, beware of any sharp burrs on the metal panel
aperture. Ensure that the fixings are properly tightened to prevent the fixings
becoming loose due to panel vibration.
c