EMKO B01 Series, Instruction Manual

Page: 13 / 28

-9-
Water supplied by connecting products
①、Connecting tee coupling to inlet angle valves.
②、Connecting short braided pipe (20cm) to tee coupling.
③、Connecting the filter to short braided pipe(20cm).
④、Connecting long braided pipe (30cm) to the filter.
⑤、Connecting long braided pipe (30cm) to water inlet connector of toilet.
⑥、Connecting tank braided pipe to tee coupling.
※ WARM PROMPT
※ After finish installation，turn on the inflow valve to make sure that the seat sensor is sensible，
and then press each button to check if the toilet is worked after sitting induction is ok.
The products has been test by water，and it is normal if dropping out little amount of water when taking
out products.
It works when light on
after pressing power
plug，the reset button.
There will be sounded
after connected to power.
1、Leakage protection
worked after pressing
test button when indicator
off.
2、Electronic reply after
pressing reset button
when indicator on.
①
②
③
④
⑤
⑥