4
©2020 EMist is a registered trademark of SanoTech 360 LLC.,
all rights reserved. EMist is a wholly owned subsidiary of SanoTech 360 LLC.
2. Initial Inspection & Set Up - Before You Use
Charge the battery first:
1. Plug cord into AC adapter.
2. Plug AC adapter cable into Smart Battery Charger.
3. Plug AC adapter into 120v wall outlet.
4. Install battery into smart charger.
5. Reference power indicator (5 bars = full charge).
With the application power pack battery slots facing
you, remove battery covers by pinching the triangle.
Install battery with tab facing left.
Gently push battery to seat.
Replace battery cover.
Depress the power button to verify power on the
power pack (LED will blink continuously).
a)
b)
c)
d)
e)
f)
With the grounding strap attached and the tank
installed, push the power button on the applicator.
The green LED on the applicator will become a steady
green light.
Once the applicator trigger switch is depressed, the
fan will turn on first, followed by the liquid spray.
The yellow LED illuminating signifies that the high
voltage power supply is charging the liquid.
Once the applicator trigger is released, the liquid will
stop and the fan will turn off after a slight hesitation to
ensure the liquid is cleared inside the applicator.
a)
b)
c)
d)
e)
Identify the white portion of the grounding strap ring
and install placing the white portion to the bottom of
the ball of your shoe.
Place elastic strap around heel.
Snap the button to the bottom of the power pack.
a)
b)
c)
1. Install Battery (procedure same for both
battery slots):
Put the Harness on the power pack.
Put the power pack on like you would a backpack and
adjust the straps to fit comfortably.
a)
b)
6. Power Pack Harness Strap
Adjustments (optional):
While gently depressing tank lid/handle, rotate
counter-clockwise about 1/4 turn. Once disengaged,
it will pop up slightly.
Lift liquid tank out of power pack.
a)
b)
2. Liquid Tank Removal:
For initial set up/test, fill the liquid tank 1/3 full with
water.
Gently place the liquid tank in the power pack.
Slightly rotate clockwise about ¼ turn while
depressing tank until you feel resistance. Handle of
tank should line up with placard on the power pack.
a)
b)
c)
3. Liquid Tank Insertion:
Raise adjustable clamp, place the power pack with
battery slots facing the handle.
Put the clamp over the hand grip of the power pack
keeping the quick connect cable out of the way. This
secures the pack in place.
Adjust the pull cart handle to your comfort.
Use the applicator holster when system is not in use.
a)
b)
c)
d)
4. Pull Cart Installation (optional):
5. Grounding Strap Installation (optional):
7. Power Pack and Applicator Function Check:
Note: Over time, the tank connector may need
adjusting to align with placard.
