22
ETL Model No.: CF590
12. Light Kit LED Array Assembly Replacement
12.2
Rotate and remove the Shade counter-clockwise to
expose the Light Kit Assembly (Figure 38).
Retain Shade for future reinstallation.
LIGHT KIT
ADAPTER/LIGHT
KIT ASSEMBLY
SHADE
ROTATE
COUNTER-CLOCKWISE
Figure 38
12.3
Loosened the two Light Kit Adapter 6-32 x 3/8” Truss Head
Screws with Lockwashers located in the key hole slots.
Remove the remaining Light Kit Adapter 6-32 x 3/8” Truss
Head Screws with Lockwasher (Figure 39). Retain for
future use.
Rotate the Light Kit Assembly counter-clockwise to
disengage the two 6-32 x 3/8” Truss Head Screws with
Lockwashers in the key hole slots for removal of Light Kit
Assembly.
LIGHT KIT ASSEMBLY
REMOVE ONE 6-32 x 3/8" TRUSS
SCREW WITH LOCKWASHER
LOOSEN TWO 6-32 x 3/8"
TRUSS HEAD SCREWS
WITH LOCKWASHERS
ROTATE
COUNTER-CLOCKWISE
Figure 39
12.1
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to replace the
Light Kit LED Array Assembly.
Tools Needed
One Phillips Head Screwdriver
One Stepladder
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
WARNING
!
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
!
