U.L. Model No.: CF3300
11
This control is designed to operate two ceiling
fans, and not any accessory light kits. The SW22
speed control is rated for 3.0 amps at 120 volts.
NOTE: Electrical connections should be in
accordance with the National Electrical Codes and
all Local Codes. Before starting, disconnect
power to the circuit at the fuse box or circuit
breaker panel.
1.
Set the SW22 Wall Control in the off position (full
counter-clockwise), and pull off the knob.
2.
Connect one BLACK wire from the SW22 Wall
Control to the supply HOT lead with a wire
connector (provided) (Figure 18).
3.
Connect the other BLACK wire from the SW22 Wall
Control to the Black LOAD wire with a wire
connector (provided) (Figure 18) .
NOTE: Use wire connectors (supplied) to secure
electrical connections.
FACEPLATE
SW22 WALL CONTROL
WALL OUTLET
BOX
6-32 SCREWS (2)
Figure 19
The SW22 Wall Control has one high speed and one
low speed setting. From the OFF position, rotate the
knob in the clockwise direction to the high position.
For low speed, rotate the knob clockwise to the next
position. Turn the fans off by fully rotating the knob
counter-clockwise to the OFF potion (Figure 20).
To avoid possible electrical shock, be sure
electricity is turned off at the main fuse box
before wiring.
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for
advice, as it must be grounded for safe
operation.
WARNING
!
4.
Position the faceplate (not provided) onto the
speed control. Using the two 6-32 screws supplied
with the faceplate, screw the faceplate and speed
control to the wall outlet box (Figure 19).
5.
Press knob onto the shaft and rotate counter-
clockwise to the full-OFF position.
6.
Restore power at the main fuse box or circuit
breaker panel.
DECORATIVE
STRAP
BUCKLE
FAN ASSEMBLY
STRAP SLOT
Figure 17
10.
This completes the installation of your ceiling fan.
How to Wire Your Ceiling
Fan - SW22 Wall Control
Control Operation:
BLK
BLK
BLUE - Not Used
BLK - TO MOTOR
WHT - TO MOTOR
GRN - From Bracket
GRN
WHT
BLK
120 VAC SUPPLY
(User Supplied)
HOT
FAN LOAD
Figure 18
Figure 20
