Quick Installation Guide
00825-0100-4004, Rev DB
December 2011
Rosemount 8800D
13
S
TEP
5: V
ERIFY
C
ONFIGURATION
Before operating the Rosemount 8800D in an installation, you should review the
configuration data to ensure that it reflects the current application. In most cases, all of these
variables are pre-configured at the factory. Configuration may be required if your 8800D is
not configured or if the configuration variables need revision.
Rosemount recommends the following variables are reviewed before startup:
HART Configuration
F
OUNDATION
fieldbus Configuration
• Tag
• Transmitter Mode
• Process Fluid
• Reference K-Factor
• Flange Type
• Mating Pipe ID
• PV Units
• PV Damping
• Process Temperature Damping
• Fixed Process Temperature
• Auto Adjust Filter
• LCD Display Configuration (For units
with a display only)
• Density Ratio (For Standard or Normal
flow units only)
• Process Density and Density Units (For
mass flow units only)
• Variable Mapping
• Range Values
• Pulse Output Configuration (For units
with a pulse output only)
• Tag
• Transmitter Mode
• Process Fluid
• Reference K-Factor
• Flange Type
• Mating Pipe ID
• PV Units (Configured in the AI block)
• Flow Damping
• Process Temperature Damping
• Fixed Process Temperature
• Auto Adjust Filter
• LCD Display Configuration (For units with
a display only)
• Density Ratio (For Standard or Normal
flow units only)
• Process Density and Density Units (For
mass flow units only)
4004_RevDB.fm Page 13 Wednesday, November 23, 2011 3:06 PM
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
