Emerson Rosemount 3308, Reference Manual

Page: 65 / 128

Reference Manual
00809-XXXX-4811, Rev AA
February 2012
5-11
Rosemount 3308
PRELIMINARY
Measurement Mode
Normally the Measurement Mode does not need to be changed. The
transmitter is pre-configured according to the specified model:
Table 5-2. Measurement Mode
Interface Immersed Probe is used for applications where the probe is fully
immersed in liquid. In this mode the transmitter ignores the upper product
level. See
Section 7: Interface Measurements with Fully Immersed Probes for
more information.
NOTE!
Only use Interface Immersed Probe for applications where interface is
measured for a fully immersed probe.
Probe Angle
Enter the angle between the probe and the vertical line. The default value is
equal to zero. Do not change this value if the transmitter is mounted with the
probe along the vertical line (which is normally the case).
Maximum Upper Product
Thickness
For interface measurements the Maximum Upper Product Thickness
parameter may be used in special cases when the dielectric constant of the
upper product is relatively high. By setting this parameter you can avoid that
interface measurements are getting out of range.
Display
Choose variabels to be displayed.
HART Comm
TO BE
ADDED
Model Measurement Mode
3308 Level, Level and Interface
(1)
, Interface Immersed probe
(1) Default setting
HART Comm
TO BE
ADDED
HART Comm
TO BE
ADDED
HART Comm
TO BE
ADDED