Your instrument purchase from Emerson is one of the finest available for your particular application. These instruments have been
designed, and tested to meet many national and international standards. Experience indicates that its performance is directly relat-
ed to the quality of the installation and knowledge of the user in operating and maintaining the instrument. To ensure their contin-
ued operation to the design specifications, personnel should read this manual thoroughly before proceeding with installation,
commissioning, operation, and maintenance of this instrument. If this equipment is used in a manner not specified by the manufac-
turer, the protection provided by it against hazards august be impaired.
•
Failure to follow the proper instructions august cause any one of the following situations to occur: Loss of life; personal
injury; property damage; damage to this instrument; and warranty invalidation.
•
Ensure that you have received the correct model and options from your purchase order. Verify that this manual covers your
model and options. If not, call 1-800-854-8257 or 949-757-8500 to request correct manual.
•
For clarification of instructions, contact your Rosemount representative.
•
Follow all warnings, cautions, and instructions marked on and supplied with the product.
•
Use only qualified personnel to install, operate, update, program and maintain the product.
•
Educate your personnel in the proper installation, operation, and maintenance of the product.
•
Install equipment as specified in the Installation section of this manual. Follow appropriate local and national codes. Only
connect the product to electrical sources specified in this manual.
•
Use only factory documented components for repair. Tampering or unauthorized substitution of parts and procedures can
affect the performance and cause unsafe operation of your process.
•
All instrument enclosures must be closed and protective covers must be in place unless qualified personnel are performing
maintenance.
WARNING
RISK OF ELECTRICAL SHOCK
Equipment protected throughout by double insulation.
•
Installation and servicing of this product august expose personnel to dangerous voltages.
•
Main power wired to separate power source must be disconnected before servicing.
•
Do not operate or energize instrument with case open!
•
Signal wiring connected in this box must be rated at least 240 V for European mains operation.
•
Non-metallic cable strain reliefs do not provide grounding between conduit connections! Use grounding type bushings and
jumper wires.
•
Unused cable conduit entries must be securely sealed by non-flammable closures to provide enclosure integrity in compliance
with personal safety and environmental protection requirements. Unused conduit openings must be sealed with Type 4X or IP66
conduit plugs to maintain the ingress protection rating (Type 4X)
•
Electrical installation must be in accordance with the National Electrical Code (ANSI/NFPA-70) and/or any other applicable
national or local codes.
•
Operate only with front panel fastened and in place.
•
Safety and performance require that this instrument be connected and properly grounded through a three-wire power source.
•
Proper use and configuration is the responsibility of the user.
Essential Instructions
Read this page before proceeding
Essential Instructions
i
