15. Securely connect the black wire from the light kit
plate assembly to the blue wire from the motor
shaft using a wire connector (supplied) (Figure
10). Connect the white wire from the plate assem-
bly to the white wire from the motor shaft using a
wire connector (supplied).
16. Secure the light kit plate assembly to the light kit
adapter assembly by threading three 8-32 x 3/8”
phillips head screws (supplied) into the threaded
holes in the adapter assembly. (Figure 11).
NOTE: Do not pinch wires between the light kit
plate assembly and the adapter assembly.
17. Lift the fan assembly from the styrofoam and
remove the center styrofoam section. Turn the fan
assembly over and carefully position it on the
upper styrofoam section so that the hanger
ball/downrod assembly is at the top (Figure 12).
LIGHT KIT
ADAPTER
ASSEMBLY
WIRE
CONNECTORS
BLUE WIRE
WHITE
WIRES
LIGHT KIT
PLATE
ASSEMBLY
BLACK WIRE
Figure 10
LIGHT KIT ADAPTER
ASSEMBLY
LIGHT KIT PLATE
ASSEMBLY
8-32 X 3/8"
PHILLIPS HEAD
SCREWS (3)
Figure 11
6
11. Reinstall the hanger ball on the downrod as
follows. Route the motor leads through the hanger
ball and slide the hanger ball over the downrod
(Figure 7). Install the pin through the holes at the
top of the downrod and slide the hanger ball up
the downrod, aligning the ball so the pin is cap-
tured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin and
securely tighten the setscrew in the hanger ball. A
loose setscrew could create fan wobble.
12. Position the center styrofoam section on the
upper section, and then position the fan motor
and housing on the center section so that the bot-
tom of the motor is facing you (Figure 8). The sty-
rofoam sections will hold the assembly while you
perform the following steps.
13. Position the flatwasher (supplied in parts bag) on
the motor shaft (Figure 8).
14. Using the 3/16” setscrew wrench (supplied),
loosen the setscrew in the collar, then screw the
light kit adapter assembly onto the motor shaft
(Figure 9). Tighten the setscrew to secure the
adapter assembly to the shaft. Securely engage
the connector from the reversing switch to the con-
nector from the motor shaft.
CEILING COVER
SETSCREW
PIN
HANGER BALL
DOWNROD
Figure 7
REVERSING
SWITCH
CONNECTORS
MOTOR SHAFT
COLLAR
SETSCREW
LIGHT KIT
ADAPTER
ASSEMBLY
Figure 9
CENTER
STYROFOAM
SECTION
FAN MOTOR AND
HOUSING ASSEMBLY
UPPER
STYROFOAM
SECTION
FLATWASHER
Figure 8
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened.
Failure to verify that the pin and setscrew are proper-
ly installed could result in the fan falling.
WARNING
!