9
9. Install the setscrew (supplied in loose parts bag) in
the motor coupling and tighten using the 5/32"
setscrew wrench (supplied) (Figure 21).
10. Screw two 1-1/4” threaded studs (provided) into
the motor (Figure 22). Leave approximately 7/8” of
the stud extending above the motor. Slide the
motor cover over the downrod and rotate the cover
until the threaded studs protrude; install two
knurled knobs (supplied) to secure the cover.
NOTE: Make sure the red and brown leads are
capped with wire connectors. Make sure red,
brown, and yellow wire connectors are completely
inside motor coupling cover and not pinched
between the motor coupling cover and motor.
11. Position the ceiling cover over the downrod. Be
sure the cover is oriented correctly, with the large
opening at the top (Figure 23).
12. Reinstall the hanger ball on the downrod as
follows. Route the motor leads through the hanger
ball and slide the hanger ball over the downrod
(Figure 23). Install the pin through the holes at the
top of the downrod and slide the hanger ball up
the downrod, aligning the ball so the pin is
captured in the groove in the top of the hanger
ball. Pull the hanger ball up tight against the pin
and securely tighten the setscrew in the hanger
ball. A loose setscrew could create fan wobble.
13. The blue, black, yellow and white leads exiting the
downrod are 80-inches long. Before installing fan,
measure up approximately 6 to 9-inches above the
ball/downrod assembly. Cut off excess leads and
strip back insulation 1/2-inch from end of leads.
NOTE: If you are installing your fan with a SR330
Remote Control or SW350 Wall Control, Do Not
Cut Terminal Off of the Yellow Lead.
(See Section A.)
SETSCREW
CLEVIS PIN
MOTOR
COUPLING
DOWNROD
HAIRPIN
CLIP
MOTOR COUPLING
HAIRPIN
CLIP
CLEVIS
PIN
DOWNROD
YELLOW LEADS TO
BE POSITIONED IN
SLOT IN MOTOR
COUPLING
CLEVIS
PIN
Figure 20
DOWNROD
SETSCREW
Figure 21
7/8"
RED LEAD
WIRE
CONNECTORS
KNURLED KNOB
1-1/4" THREADED
STUD
MOTOR
BRACKET
MOTOR
COUPLING
COVER
WIRE CONNECTOR
YELLOW LEADS
BROWN LEAD
Figure 22
CEILING COVER
SETSCREW
PIN
HANGER BALL
DOWNROD
Figure 23
It is critical that the clevis pin in the motor coupling
is properly installed and the setscrew securely tight-
ened. Failure to verify that the pin and setscrew are
properly installed could result in the fan falling.
WARNING
!
It is critical that the pin in the hanger ball is properly
installed and the setscrew securely tightened.
Failure to verify that the pin and setscrew are proper-
ly installed could result in the fan falling.
WARNING
!
