ON
1
2
3
4
RECEIVER SWITCH
LEVERS
CODE
SWITCH
SW105 RECEIVER
CODE
SWITCH
WALL
CONTROL
WALL CONTROL
LEVERS
ON
1
2
3
4
LIGHT
HI
HI
MED
MED
LOW
LOW
FAN OFF
Turning off wall switch is not sufficient.
To avoid possible electrical shock, be
sure electricity is turned off at the main
fuse or circuit breaker box.
!
WARNING
13
Battery Installation of
Wall Control
Figure 24
Setting Operating
Frequency of Wall
Control and Receiver
(Figure 24)
Your wall control and receiver have code
switches which must be set in one of 16
possible code combinations. The four
levers (numbered 1, 2, 3, and 4) on the
switches are factory-set in the ON (up)
position. Change the switch settings as
follows:
1. Slide the four switch levers in the wall
control to your choice of ON (up) or
down positions. Use a ball-point pen or
small screwdriver and slide the levers
firmly up or down.
2. In the receiver, slide the four switch
levers to the same positions as set in
the wall control. Make sure the levers
on both switches are in the same
positions, otherwise the fan will not
operate.
The wall control transmits the
command signals via radio waves to
the SW105 receiver installed in the
ceiling fan ceiling cover. The SW105
receiver is required for the wall control
to function. Power for the wall control
comes from the 12V battery, located in
the wall control.
Replacement 12V batteries recom-
mended are Duracell MN21, Eveready
A23, and GP23A.
1. Install the 12V battery (supplied) into
the wall control (Figure 25).
2. The wall control is supplied with a white
or almond color cover. Choose the style
that best suits your needs and snap the
cover onto the wall control (Figure 25).
WALL
CONTROL
WALL CONTROL
COVER
12V BATTERY
HI
HI
MED
MED
LOW
LOW
FAN OFF
EMERSON
U/L
D/L
LIGHT
Figure 25
BP7333 CF750 MAYA ZEN 12/22/06 7:59 AM Page 13
