1. Install PM250SSP per installation instructions shipped with power module.
2. Remove aluminum filter and attach the
CHARCOAL FILTER
(included) to the backside of the
aluminum filter with the 4 supplied metal clips.
3. Cut hole in bottom of
SOFFIT
to allow clearance for the
90° ANGLE BOOT
.
4. Locate top of
4¼” X 10¼” OPENING
on soffit - centered on
POWER MODULE CENTERLINE
and
26.125”
above bottom of
POWER MODULE
.
5. Layout 4¼” x 10¼” pattern and cut opening in soffit.
6. Connect
90° ANGLE BOOT
to
7” ROUND DUCT
.
7. Insert boot end into soffit and connect 7” round duct end to the exhaust of the unit.
8. Install
GRILLE
(included - not shown) into soffit opening.
9. Use metal foil tape to make all connections secure and air tight.
INSTALLATION INSTRUCTIONS
358NDK DUCTLESS CONVERSION KIT FOR THRU SOFFIT VENTING
FOR USE WITH PM250SSP POWER MODULE
SOFFIT
CABINET
90°
ANGLE BOOT
(included)
7-IN. ROUND DUCT
(included)
PM250SSP
POWER MODULE
OPTIONAL METAL LINER
(LB30SS or LB36SS)
(purchase separately)
4¼” x 10¼”
SOFFIT OPENING
POWER MODULE
CENTER LINE
CL
26.125”
CHARCOAL FILTER
(included) (99010464)
