IC200CX EVO
user manual
16
6.2 Modify the set point
The modification of the set point is only possible for the current unit mode (chiller or heat pump) and
for domestic hot water management if active.
Press for at least 3 seconds.
The display will show
SetC
or
SetH
depending on
the operating mode in the lower line. The blinking
value of the set set will be displayed in the upper
line.
Use the keys and to modify the
set point value.
To confirm the new set point, press or wait
for the time out to exit programming.
3 seconds
When the unit is operating: when the button is pressed for the first time, the lower display
shows
SEtC
(set chiller) or
SEtH
(set heat pump), depending on the unit mode, and the upper display
shows the set value. Pressing again, with the energy saving or with the dynamic set point activated
(par. 6.3), the lower display shows the label
SEtr
(real set) and the upper display shows the actual
working set point of the unit. Press the button again to display the domestic hot water set point
SEtS
(if the function is activated).
