Liebert GXTRT Series Installation and User Manual
1-3 kVA UPS
Page 13
9/2005
Emerson Network Power
Installation
2.3 Tower Installation
2.3.1 Installing Single Power Module
Use the following steps to install the UPS systems that contain only one power module and no
battery module. These power modules include GXT1000-RT, GXT1000L-RT, GXT2000L-RT
and GXT3000L-RT.
1. Take out a pair of support bases delivered with the power module, snap it up in the direction
shown in the left figure below to make a base, and put it down flat on the installation surface, as
shown in the right figure below; likewise, make another base using another pair of support
bases, and put it down flat on the installation surface.
Figure 2-1 Making base
2. As shown in the left figure below, move the two bases to appropriate positions, and put the
power module gently down on the bases; then push the power module gently in the directions
shown in the right figure below to position it evenly on the two bases.
Figure 2-2 Positioning power module
2.3.2 Installing Power Module Plus Battery Module
Use the following steps to install the standard UPS systems that contain a power module and a
battery module (i.e., GXT2000-RT plus GXT2000-BAT; and GXT3000-RT plus GXT3000-BAT).
1. Take out a pair of support bases delivered with the power module, and a support base
extension delivered with the battery module, use step 1 in section 2.3.1 to fit them together
to make a base, and put it down flat on the installation surface, as shown in Figure 2-3;
likewise, make another base and put it down flat on the installation surface.
Figure 2-3 Making base
