![Emerson FloBoss 103 Instruction Manual Download Page 98](http://html.mh-extra.com/html/emerson/floboss-103/floboss-103_instruction-manual_102406098.webp)
FloBoss 103/104 Instruction Manual
A-6
Glossary
Revised August-2017
N
(continued)
Node
A basic structural component of the Distributed RTU Network. A node (usually a FB107
chassis housing a focused-functionality CPU and a Network Radio module) provides a
data collection point that wirelessly transmits data throughout the designed network.
NRM
Network Radio module; a module used in both the FloBoss 107 and ROC00-Series
based devices to wirelessly transmit information throughout the distributed RTU
network.
O
OH
Off-Hook modem communications signal.
Off-line
Accomplished while the target device is not connected (by a communications link). For
example, “off-line configuration” refers to configuring an electronic file that is later
loaded into a ROC.
Ohms
Units of electrical resistance.
On-line
Accomplished while connected (by a communications link) to the target device. For
example, “on-line configuration” refers to configuring a ROC800-Series unit while
connected to it, so that you can view the current parameter values and immediately
load new values.
Opcode
Type of message protocol the ROC uses to communicate with the configuration
software, as well as host computers with ROC driver software.
Operator
Interface
Also LOI or Local Port; the serial EIA-232 (RS-232) port on the ROC through which
local communications are established, typically for configuration software running on a
PC.
Orifice meter
A meter that records the flow rate of gas through a pipeline. The flow rate is calculated
from the pressure differential created by the fluid passing through an orifice of a
particular size and other parameters.
P, Q
Parameter
A property of a point that typically can be configured or set. For example, the Point Tag
ID is a parameter of an Analog Input point. Parameters are normally edited by using
configuration software running on a PC.
PC
Personal Computer.
Pf
Flowing pressure.
P/DP
Pressure/Differential Pressure.
PI
Pulse Input.
PID
Proportional, Integral, and Derivative control feedback action.
PIT
Periodic Timer Interrupt.
PLC
Programmable Logic Controller.
Point
Software-oriented term for an I/O channel or some other function, such as a flow
calculation. Points are defined by a collection of parameters.
Point Number
The physical location of an I/O point (module slot and channel) as installed in the ROC.
Point Type
Defines the database point to be a specific type of point available to the system. The
point type determines the basic functions of a point.
Preset
Number value previously determined for a register.
PRI
Primary PID control loop.