Emerson Fisher FIELDVUE DVC6000, Instruction Manual

Page: 12 / 162

DVC6000 Digital Valve Controllers
September 2013 1-2
Table 1-1. Instrument Level Capabilities
CAPABILITY
DIAGNOSTIC LEVEL
(1)
AC HC AD PD ODV
Auto Calibration X X X X X
Custom Characterization X X X X X
Burst Communication X X X X
Alerts X X X X
Step Response, Drive Signal Test & Dynamic Error Band X X X
Advanced Diagnostics (Valve Signature) X X X
Performance Tuner X X X
Travel Control - Pressure Fallback X X X
Performance Diagnostics X X
Solenoid Valve Testing X X
Lead/Lag Input Filter
(2)
X
1. See page 6-8 for additional diagnostic level information.
2. Refer to brochure part # D351146X012/D351146X412 for information on Fisher optimized digital valves for compressor antisurge applications.
Scope of Manual
This instruction manual includes specifications,
installation, operating, and maintenance information
for device revision 1, firmware revision 2
−
6 and device
revision 2, firmware 7, 9, 10, and 11 digital valve
controllers, instrument level AC, HC, AD, PD, and
ODV.
This instruction manual describes using the 475 Field
Communicator with device description revision 8 to
setup and calibrate the instrument. You can also use
Fisher ValveLink software version 7.3 or higher to
setup, calibrate, and diagnose the valve and
instrument. For information on using ValveLink
software with the instrument refer to ValveLink
software help or documentation.
Do not install, operate, or maintain a DVC6000 digital
valve controller without being fully trained and qualified
in valve, actuator, and accessory installation,
operation, and maintenance. To avoid personal
injury or property damage, it is important to
carefully read, understand, and follow all of the
contents of this manual, including all safety
cautions and warnings. If you have any questions
about these instructions, contact your Emerson
Process Management sales office before proceeding.
Conventions Used in this Manual
Procedures that require the use of the 475 Field
Communicator have the Field Communicator symbol
in the heading.
Procedures that are accessible with the Hot Key
on the Field Communicator will also have the Hot Key
symbol in the heading.
Figure 1-1. Sliding-Stem Control Valve with
FIELDVUE DVC6010 Digital Valve Controller
W7957 / IL
Some of the procedures also contain the sequence of
numeric keys required to display the desired Field
Communicator menu. For example, to access the
Setup Wizard, from the Online menu, press 1 (selects
Configure) followed by a second 1 (selects Basic
Setup) followed by a third 1 (selects Setup Wizard).
The key sequence in the procedure heading is shown
as (1-1-1). The path required to accomplish various
tasks, the sequence of steps through the Field
Communicator menus, is also presented in textual
format. Menu selections are shown in italics, e.g.,
Calibrate. An overview of the Field Communicator
menu trees are shown at the beginning of this manual.
1