Quick Start Guide
D103470X012
DLC3020f Digital Level Controller
April 2022
29
EXPERT USER
CALIBRATIONS TAB
FULL CALIBRATION
TRIM CURRENT CALIBRATION
CONFIGURE
CALIBRATE
Figure 19. Expert User Calibrations
Calibration Descriptions
Full Calibration
Weight
(Bench only)
—Weight Calibration is a bench calibration where weights are used to simulate the different forces
the device sees at the minimum and maximum levels. All configuration data is needed to perform a Weight
calibration. Weights are suggested based on the current density values so that the two weights closely simulate the
minimum and maximum points the device should see, or based on water for certain setups. These are suggested
values only; you can enter other values if desired.
Note
The larger the difference in the weights, the better the calibration will be, provided that the unit is not on a mechanical stop.
Note
Ensure that the moment arm is not resting on a travel stop during the calibration process. Also, the weights tend to oscillate when
placed on arm, so allow sufficient time for this to dissipate before capturing the points.
