Instruction Manual
D200160X012
4195K Controllers
July 2018
11
Figure 2‐3. Panel Mounting
HEX HEAD
CAP SCREW
(KEY 66)
LOCK
WASHER
(KEY 67)
ROUND
HEAD
MACHINE
SCREW
(KEY 70)
BRACKET
(KEY 68)
TOP VIEW
36A9760‐A
A6733
84
(3.29)
63
(2.49)
306
(12.06)
14
(0.56 R)
236
(9.31)
mm
(INCH)
13
(0.50)
62
(2.43)
REAR VIEW
DIMENSIONS OF
PANEL CUTOUT
Wall Mounting
Using the dimensions in figure 2‐4, drill holes in the wall to align with the four holes in the bracket (key 68). If the
tubing is to run through the wall, drill a hole in the wall large enough to accept the tubing. Mount the controller to the
bracket using three cap screws (key 66) and lock washers (key 67). Attach the bracket to the wall, using suitable screws
or bolts.
Figure 2‐4. Wall Mounting
HEX HEAD
CAP SCREW
(KEY 66)
LOCKWASHER
(KEY 67)
BRACKET
(KEY 68)
TOP VIEW
36A9761‐B
A6734
161
(6.35)
260
(10.25)
152
(6.00)
62
(2.43)
13
(0.50)
13
(0.50)
REAR VIEW
mm
(INCH)
Actuator Mounting
Refer to figure 2‐1. A controller specified for mounting on a control valve actuator is mounted at the factory. If the
controller is ordered separately for installation on a control valve actuator, mount the unit as described in this section.
Mounting parts vary for different actuator types.
Attach the mounting bracket to the actuator yoke with cap screws, lock washers, and spacer spools. Attach the
controller to the bracket with cap screws, lock washers, and spacer spools. On some designs, the mounting bracket is
attached to the actuator casing rather than to the yoke.
