14
U.L. Model No.: CF135
5. Light Kit Assembly
This Section Will Instruct How to Install the Light Kit
Assembly. If Not Using the Light Kit, Skip this Entire
Section.
5.1
Locate the rubber plug from the hardware pack and install
it into the blade installation slot of the switch housing plate
by firmly pushing it into the slot (Figure 25).
NOTE: The rubber plug must be installed to prevent
water penetration of the switch housing assembly.
RUBBER PLUG
BLADE
INSTALLATION
SLOT
Figure 25
5.2
Remove the three pre-installed #8-32 x 0.3” flat head
screws from switch housing plate (Figure 26).
Retain the three switch housing plate screws for future
installation.
#8-32 x 0.3" FLAT HEAD
SCREWS (3)
SWITCH HOUSING PLATE
Figure 26
4. Switch Cup Assembly Only
(Continued)
4.11
Securely reinstall the three previously removed
#8-32 x 0.3” flat head screws into the aligned holes with a
phillips screwdriver (Figure 24).
Installation of the switch cover is now complete,
skip Section 5 and proceed to Section 6.
A spare #8-32 x 0.3” flat head screw is supplied in the
parts bag, if needed.
SWITCH
COVER
x 3
SWITCH COVER
SCREWS (3)
Figure 24
