11
6.
Screw in two 60-watt (maximum)
candelabra base bulbs (supplied) in
the light kit assembly sockets (Figure
To avoid possible fire or shock, make
sure that the electrical wires are
completely inside the outlet box and
not pinched between the ceiling
cover and the ceiling.
!
WARNING
3.
Screw the two 1-1/4” threaded studs
(supplied) into the tapped holes in the
hanger bracket (Figure 13).
4.
Lift the ceiling cover up to the threaded
studs and turn until the studs protrude
through the holes in the ceiling cover
(Figure 15).
5.
Secure the ceiling cover in place by
sliding lockwashers (supplied) over
the threaded studs and installing the
two knurled knobs (supplied). (Figure
15). Tighten the knurled knobs
securely until the ceiling cover fits
snugly against the ceiling.
#8 EXTERNAL
TOOTH
LOCKWASHER (2)
CEILING
COVER
1-1/4"
THREADED
STUD (2)
#8-32 KNURLED
KNOB (2)
Figure 15
LIGHT KIT ASSEMBLY
SOCKET (2)
60-WATT (MAX.)
CANDELABRA BASE BULB (2)
Figure 16
FLAT AREA (3)
RAISED
DIMPLE (3)
GLASS
BOWL
LOWER
HOUSING
ASSEMBLY
Figure 17
7.
Place the glass bowl into the opening
in the lower housing assembly,
aligning the three flat areas on the top
edge of the glass with the three raised
dimples on the lower housing
assembly and turn the glass bowl
clockwise until it stops (Figure 17).
NOTE: periodically check that the glass
bowl is seated fully clockwise in the
lower housing assembly.
UL Model No.: CF930
BP7332-2 CF930 Atomical 9/23/10 3:29 PM Page 11
