9
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF717
The outlet box and joist must be securely mounted and
capable of supporting at least 50 lbs. Use only a U.L.
outlet box listed as “Acceptable for Fan Support of
22.7 kg. (50 lbs.) or less”.
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked “Acceptable for
Fan Support of 22.7 kg. (50 lbs.) or less”, and use
screws supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are not
acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
WARNING
!
5.1
Unscrew (but do not remove) the two mounting screws
in the outlet box (Figure 12). Position the hanger
bracket on the outlet box so that the T-slots in the
hanger bracket are aligned with the outlet box screws.
NOTE: The hanger bracket must be mounted flush
with the ceiling in order for the ceiling cover to
install properly. If necessary, use leveling washers
(not supplied) between the outlet box and the
hanger bracket.
HANGER
BRACKET
LOOSEN TWO
SCREWS (SUPPLIED
WITH OUTLET BOX)
OUTLET BOX
SLIDE THE HANGER
BRACKET ONTO
THE OUTLET BOX
SCREWS, THROUGH
THE T-SLOT
T-SLOT
Figure 11
5. Installation of Hanger Bracket
The fan must be hung with at least 7' of clearance from
floor to blades (Figure 11).
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
WARNING
!
HANGER BRACKET
HOOK
SECURELY
TIGHTEN
SCREWS
Figure 12
BP7483 ASHLAND CF717 12/19/13 9:59 AM Page 9
