DISCONNECTION
De-energise connectors
BEFORE STARTING
• Fully loosen the cover screw.
• With a standard screwdriver, unclip the lugs on each side of the connector as shown in Fig.7.
• Remove the cables.
• Remove or replace the connector.
• Reinstall a new connector as per the above procedure.
NOTE - In the event of removal or insertion of product, the installation
remains serviceable in its new configuration.
ASI
Pow
er
ASI
Po
we
r
!
This product contains electronic components sensitive to electrostatic
discharge. If a person or an object come in contact with the electrical
components of the product, there will be an electrostatic charge which
can damage or destroy the product.
To reduce the risk of electrostatic discharge, please observe the handling
precautions and recommendations contained in standard EN100 015-1
at all times. Do not connect or disconnect this device when it is energised.
E S D
WARNING
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
DISCHARGE
SENSITIVE DEVICES
ASinterface CONNECTORS - SERIES 881
MS-P522
INSTALLATION
ASI
Po
we
r
1
3
2
3
AS
I
Po
we
r
A
30
ASI
Po
we
r
ASI
Po
we
r
1
2
fig.1
fig.3
fig.5
fig.6
fig.7
ASI
Po
wer
fig.4
8
10
!
fig.2
!
• These connectors are suitable for coils with a power rating of 24V DC (-15 or
-10%
, +10%)
• The two lugs on the cover are of different widths to ensure that the connectors
and the cables are oriented correctly (Fig.2)
•
ASinterface connectors are non-rotatable.
• Connectors with M12 inputs are available in two versions (A and B), with
M12 orientation through 180° to fit any product configuration.
• It is recommended to connect the wiring
before
mounting on the coil.
CONNECTION
• Before connection, determine the mounting direction of the connector on
the product coil on the basis of the position of the earth connection.
• The connector is supplied with the cover pre-mounted. Remove the cover
to connect the wiring (Fig.1).
• Completely unscrew the cover screw.
• With a standard screwdriver, unclip the lugs on each side of the lid.
• Place the cables in the cover grooves (Fig.3) in accordance with the en-
graved markings on the top.
- black cable
1
under “POWER”
- yellow cable
2
under “ASinterface”.
• Reinstall the cover on the connector (Fig.4), orientating it correctly (side
lugs with different widths).
• Exert sufficient pressure to engage the four vampire connections and clip
the cover in place.
• Maintain pressure on the cover and tighten the screw.
• Install the connectors on the coils.
• Connect any M12 input connectors, proceeding in accordance with the
instructions on the previous page.
To ensure IP65 leaktightness and prevent short cut on the end line of all
ASinterface connectors:
- At the end of each line or branch of the installation, cut the cables at
least 30 mm
after the last
connector (Fig.5).
- Fit the 2 flat cables with thermoretractable end-fittings
(available as accessories)
- Shrink these end-fittings at a temperature > 135°C
- Check that gaskets are fitted (Item A) and that connectors and covers
are tight (Fig.6).
When connecting the black cable to the power supply unit
24V DC (
-5%
, +10%),
observe polarity: blue to - and brown to +.
