- 12 -
Sometimes, it is necessary to heat the seal at a low temperature in order to give him back his elasticity, then he
resumes its good position and tightness gradually.
CLEANING AND MAINTENANCE
Defrosting
Your appliance is designed with a "natural" defrosting system. When the engine is shut down, the refrigerated
surfaces of the appliance will automatically defrost. The de-icing water descends into a drainage container near
the compressor at the back of the appliance. This water is evaporated by the heat produced by the compressor.
Important:
Keep the drain and gutter clean to prevent it to clog and water to flow inside the appliance.
Cleaning
Before cleaning or restarting, unplug at the socket.
Never use abrasive products or sponges with scrapers for cleaning inside or outside your device.
•
Remove all accessories (e.g., shelves, water pan located at the bottom of the back of the appliance). Wash
them with lukewarm water with a mild, odorless detergent (an unscented dish liquid, for example), rinse
with water containing bleach and dry thoroughly.
•
Wash the interior walls in the same way; take special care of the shelves.
•
Wash the door seal without omitting to clean also under the door seal.
•
Reconnect the device and get it back into operation.
Important!
When the appliance is not used:
•
Unplug the appliance.
•
Remove all objects inside.
•
Clean and dry the interior space of the appliance per the above instructions.
•
Leave the door slightly ajar to avoid mold.
TROUBLESHOOTING
Some issues can be easily resolved. Before using after-sales service or a repairman, please see the following
table:
PROBLEM
POSSIBLE CAUSES
The appliance doesn't work.
The appliance is not plugged in or it is switched off.
The circuit breaker is triggered, or the fuse is damaged.
Check to see if the power outlet is powered by connecting another electrical
appliance.
The appliance is not cold
enough.
Check the temperature setting. A high ambient temperature may require a
lower setting.
The door opens too often.
The door is not completely closed.
The door seal is not properly positioned.
The compressor works and
goes out often.
The room temperature is warmer than normal.
A large quantity of bottles has been added to the appliance.
The door opens too often.
The door is not completely closed.
Temperature control is not properly defined.
The door seal is not properly positioned.
The light doesn't work.
The socket is not plugged in.
The circuit breaker has gone off or a fuse is damaged.
Vibration.
The appliance may not be level.
Summary of Contents for WV-126431
Page 1: ......
