EMC IZS31 Series, Manual

Page: 19 / 39

Symbol Cable colour Description Connection
DC1 (+) Brown Power supply 24 VDC
DC1 (–) Blue Power supply GND [FG]
OUT4 Green Sensor monitor output
Determining the Model and Settings
6) Wiring of power supply cable
· Connect the dedicated power supply cable.
Connection with ionizer driving power supply
∗
DC1 (–) [Blue] is sure to ground it according to class-D. If the
Wiring of input/output signal power suply
Symbol Cable colour Description Connection
DC2 (+) Red Power supply 24 VDC
DC2 (–) Black Power supply GND
IN1 Yellow green
Discharge
stop signal
IN2 Gray Maintenance start signal
— White —
— Orange —
OUT1 Peach
Static electricity removal
completion signal
OUT2 Yellow Maintenance output signal
OUT3 Purple Irregular signal
: Minimum wiring requirement for ionizer operation
: Wiring
necessary to use various functions
—: Wiring not required in the sensing DC mode. Exercise caution
7) Air piping
· For single-side piping, block the unused port with
Ionizer
Series
Connection needs Contents
Ionizer driving power supply cable
Outputs the workpiece’s electrostatic
potential as an analogue signal (1 to 5 V).
Settings 1 / Sensing DC Mode
supply
the terminal is not grounded, the ionizer may malfunction.
cable
Connection needs Contents
Input/output signal power supply cable
Signal for enabling/disabling discharging
(NPN specification) Discharging is enabled when connected
(PNP specification) Discharging is enabled when connected
Signal to be input when determining the necessity of electrode
—
—
—
—
Signal to be output when the workpiece’s electrostatic potentia
when electrode needle contamination is being detected.
Signal to be output when electrode needle maintenance
Outputs signal when there is irregular high voltage, irregular sensor, irregular
caution to ensure that this wire does not short-circuit to other wires.
with the M-5P plug supplied with the ionizer.
Series
IZS31
DC power supply
Brown
Blue
Class-D ground
+24 VDC
GND
connected to DC2 (–) [Black].
connected to DC2 (+) [Red].
electrode needle maintenance
electrostatic potential is outside ± 30 V or
is necessary.
irregular CPU (B type contact output)