24
IND101057-27
3 Feb. 2021
Hatteland Technology AS | www.hattelandtechnology.com | Enterprise no: NO974533146
Page 24 of 66
Color & Filter
⚫
AWB Mode
-
Select Auto Tracing White, Auto White or Manual mode
⚫
Brightness: Controls input video brightness by selecting values between 0 and 255
⚫
Contrast: Controls input video contrast by selecting values between 0 and 255
⚫
Saturation: Controls input video saturation by selecting values between 0 and 255
⚫
Noise Filter: Noise Filter (NR) is used in order to obtain a high quality output image and
enhance compression efficiency. This camera offers Edge Preserving 2D NR and Motion
Adaptive 3D NR
⚫
2D Level: It enhances image quality by removing noise using information around pixels in a
frame.
⚫
3D Level: The higher level is, the less noise in the video. However, it can cause image distortion.
It should be configured by circumstances of use
r’s.
⚫
3D Threshold: Users can limit point for noise filter.
⚫
Edge Filter: Users are allowed to configure to have sharp and clear edge in the video.
⚫
Edge Level:
-
Default is 50. Lower than default, edge appears less sharp.
-
Higher than 50, edge appears sharper but with low exposure, noise will appear.
⚫
Defog: When the surrounding area of the subject is foggy and low contrast, the defog mode
will make the subject appear clearer
⚫
Lens Distortion Correction: With wide angle of view lens, there are image distortions on the
screen.
This mode is used for image distortion correction. However, the angle would be
narrower.
Figure 7 Setup, Image, General, Config Set#1, Color & Filter
