11
•
PRINTED MEDIA
•
RUBBER ROLLS
•
DOUBLE SIDE LAMINATE
Working process of the laminator
Adhesives without protective liner (application tape, double-sided adhesive films)
make one print self-adhesive:
Easylam-Cutter II
Special knives for the optimal equipment of our laminator with laminating films. There are various procedures
for equipping our laminators with laminate. For easy and economical handling we recommend ours:
• Open the laminating rollers (see description on the keypad on page
5) by pressing the ▼ or „
OPEN
“ key and place the laminate in the
machine as shown in the figure below. Make sure that the film lies
completely smooth on the roller and that it does not have any
wrinkles or waves. Secure the film by attaching it lightly to the rear
work surface (tape).
•
Close the roller opening by pressing the ▲ key at a distance of
about 1 cm. In this phase, the film can become loose and may no
longer adhere perfectly to the roller. Smooth the film again so that
it is slightly stretched.
• After you have placed the print to be laminated under the upper laminating
roller, close the rollers completely. Use the „
CLOSE WARM
“ or „
CLOSE
COLD
“ button to close the rollers. If the print media is not stiff, place the
laminate so that it extends over the rubber roller and the slot to the work
surface so that it sticks when the machine starts up.
Easylam-Cutter II. Item no.: 26441
This knife has a special blade.
The risk of injury or damage to the roller
of the laminator is considerably reduced.
The advantages of the Easylam Cutter II:
• You save time and material by clamping
the laminate including the carrier material (liner).
• No exposed knife tip.
The following description of the mode of operation enables an economical consumption of laminate when
loading the laminator with the film. The preparation of the machine is simplified and can therefore be learned
more quickly.
You can obtain this tool from specialist dealers or at www.dataplot.de
