13
PCA-6782 User Manual
Chapter 2
C
onnecting
Peripherals
&
Jumper
Settings
2.3
Floppy Drive Connector (FDD1)
Figure 2.2 PCA-6782 FDD1 location
You can attach one floppy disk drives to the PCA-6782's on board controller. You can
use 3.5" (720 KB, or 1.44 MB) drives.
The single board computer comes with a 34-pin daisy-chain drive connector cable.
On one end of the cable is a 34-pin flat-cable connector. On the other end are two
sets of 34-pin flat-cable connector (usually used for 3.5" drives). The set on the end
(after the twist in the cable) connects to the A: floppy drive. The set in the middle con-
nects to the B: floppy drive.
FDD1
Summary of Contents for PCA-6782
