Elvox SL24.W, Installer Manual

Page: 20 / 24

18
SL24.W
7 - Diagnostics:
7.1 - Signalling
Signalling indications are shown on the display for events of interest to the installer concerning normal and anomalous
operation. They appear on the display when the associated event occurs. These indications may signal a failure if some
of the system components are not working (e.g. photocells).
The following table gives the list of indications shown to the installer:
Signal Description
C1 Contact closed on command C1 input
C2 Contact closed on command C2 input
C3 Contact closed on command C3 input
C4 Contact closed on command C4 input
S1 Contact open on safety device S1 input
S2 Contact open on safety device S2 input
S3 Contact open on safety device S3 input
S4 Contact open on safety device S4 input
FO1 Opening limit switch position reached
FC1 Closing limit switch position reached
OBO Obstacle detected on opening
OBC Obstacle detected on closing
AF1 Motor in stop approach force reduction interval
MSO1 Mechanical stop reached in opening
MSC1 Mechanical stop reached in closing
BATT
Operation with battery.
When this message is displayed it is followed by an indication of the battery operating voltage, e.g.
24.5V
BT- Battery almost flat (indication shown only when the gate is stopped)
BT-- Battery totally flat (indication shown only when the gate is stopped)
RX Radio command received from saved remote control or from App
NX Radio command received from unsaved remote control button
RD Rolling/fixed code decoding off
OAB Gate left open
AT Gate in self-calibration
EN
7.2 - Alarms
Alarms are generally indications on the display of operating failures which prevent the automation system from work-
ing. They appear on the display when the associated event occurs. The alarms generally signal wiring errors, but may
also indicate control panel or gear motor failures.
The following table gives the list of alarms shown to the installer:
Alarm Description
XXXX Reset card
MNP Manoeuvre interval since last maintenance reached alarm
F0 Error motor not selected
F1 Motor cables inverted error
F3 Reversed limit switch error
F4 Both open limit switch alarm
F5 Opening limit switch malfunction error
F6 Closing limit switch malfunction error
F9 Communication error with expansion card
F10 Error alarm motor not connected
F12 Encoder error alarm
F14 Microswitch undervoltage (check power supply and outputs)
F15 Safety test 1 failed
F16 Safety test 2 failed
F17 Safety test 3 failed
F18 Safety test 4 failed
F19 Manoeuvre length/timeout alarm
F21 Mosfet short alarm
F23 Blocked rotor alarm
F25 Overlapping leaf in closing alarm
F26 5th obstacle in closing alarm
F27 Overcurrent alarm
F29 Radio memory full alarm
F30 Faulty radio memory alarm
F31 Short flashing alarm
F32 Gate open light short alarm
F33 No memory card alarm
F34 FW checksum alarm
F36 Board temperature alarm