Safety Instruction
These instructions are intended to ensure that the user can use the product correctly to avoid danger or property loss.
The precaution measure is divided into ‘Warnings’ and ‘Cautions’:
Warnings:
Serious injury or death may be caused if any of these warnings are neglected.
Cautions:
Injury or equipment damage may be caused if any of these cautions are neglected.
Warnings:
Follow these safeguards to prevent serious injury or
death.
Cautions:
Follow these precautions to prevent potential injury
or material damage.
Warnings:
1.
In the use of the product, you must strictly comply with the electrical safety regulations of the nation and re-
gion.
2.
Source with DC 12V or AC 24V (Whether supporting AC 24V lies on the specific camera model) according to
the IEC60950-1 standard. Please refer to technical specifications for more details.
3.
Do not connect several devices to one power adapter as an adapter overload may cause over-heating and
can be a fire hazard. If use the POE as the power supply, please make sure that the POE Switch have the suf-
ficient power .(Whether supporting PoE power supply lies on the specific camera model)
4.
Please make sure that the plug is firmly inserted into the power socket.
5.
When the product is installed on a wall or ceiling, the device should be firmly fixed.
6.
If smoke, odor, or noise rise from the device, turn off the power at once and unplug the power cable, then con-
tact the service center.
7.
If the product does not work properly, please contact your dealer or the nearest service center. Never attempt
to disassemble the camera yourself. (We shall not assume any responsibility for problems caused by unau-
thorized repair or maintenance.)
Cautions:
1.
Make sure the power supply voltage is correct before using the camera.
2.
Do not drop the camera or subject it to physical shock.
3.
Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a bit of ethanol and
wipe it gently. If the camera will not be used for an extended period of time, put on the lens cap to protect the
sensor from dirt.
4.
Do not aim the camera at the sun or extra bright places. A blooming or smear may occur otherwise (which is
not a malfunction however), and affecting the endurance of sensor at the same time.
5.
The sensor may be burned out by a laser beam, so when any laser equipment is being used, make sure that
the surface of the sensor will not be exposed to the laser beam.
6.
Do not place the camera in extremely hot or cold temperatures (the operating temperature should be between
-10°C~+60°C, dusty or damp locations, and do not expose it to high electromagnetic radiation.
7.
To avoid heat accumulation, good ventilation is required for a proper operating environment.
8.
While shipping, the camera should be packed in its original packing, or packing of the same texture.
9.
Regular part replacement: a few parts (e.g. electrolytic capacitor) of the equipment should be replaced regu-
larly according to their average life time. The average time varies because of differences between operating
environment and usage history, so regular checking is recommended for all users. Please contact with your
dealer for more details.
10. Improper use or replacement of the battery may result in hazard of explosion. Replace with the same or equi-
valent type only. Dispose of used batteries according to the instructions provided by the battery manufactu-
rer.
31
EN