WOP-2ac quick manual
5
3 Configuration of WOP-2ac network parameters
For remote management of WOP-2ac, you should set network parameters of the device according to the settings
of the network that you intend to use.
In
«Manage»
menu, open
«Ethernet
Settings»
tab and perform the following:
•
Management VLAN ID
– set the number of VLAN that you are going to use for access point management. 1
is used in the given example.
•
Connection
Type
– select «Static IP» to set IP addresses for access points manually. Specify the IP address
of WOP-2ac (in the example, it is 192.168.15.250) in «
Static IP Address
» field. Enter the address of the
default gateway in «
Default Gateway
» field. 192.168.15.1. Changing the network mask is optional. If you
want the access points to obtain IP addresses via DHCP, «Connection type» field should be set to «DHCP»
value. If DHCP is selected, the network settings configuration is completed.
Click «
Update
». Since that, WOP-2ac is available in 1 VLAN via 192.168.15.250 address.
Before changing the settings, make sure that the managing computer has the access to the access point. If you
make a mistake while changing the settings, you may undo them by resetting the access point to factory settings.
To perform this, press and hold «F» button on the side panel of the device for 20 seconds until the indicator on the
front panel is blinking.