WB-2P-LR5. User manual
21
•
•
•
•
•
•
•
•
•
•
•
•
•
minimum value is 0% (no packets were successfully sent). The parameter value is calculated for the last 10
s;
Link Quality Common
– parameter that displays the status of the link, calculated based on the number of
sent retransmit packets. The maximum value is 100% (all transmitted packets were sent on the first
attempt), the minimum value is 0% (no packets were successfully sent). The parameter value is calculated
for the entire connection time;
RSSIVertical/Horizontal
– level of signal received from base station, dBm;
SNR
– signal/noise ratio, dB;
TxRate
– channel data rate of transmission, Mbps
;
RxRate
– channel data rate of receiving, Mbps
.
Press «Refresh» button to update the page.
5.1.2 The «WDS» submenu
You may view radiointerface settings and wireless bridge state in WDS submenu.
Radio:
Channel
– a channel of wireless bridge;
Channel Bandwidth
– channel bandwidth used for wireless bridge;
Network mode
– the current network mode of the radiointerface.
WDS:
MAC address
– MAC address of the opposite device;
Client Name
– network name of the opposite device;
IP address
– IP address of the opposite device;
Link Capacity
– parameter that reflects the effectiveness of the use of a modulation by the device on the
transmission. It is calculated based on the number of packets transmitted on each modulation, and the
reduction factors. The maximum value is 100% (means that all packets are transmitted at maximum
modulation for the maximum nss type supported by the device). The minimum value is 2% (in the case
when the packets are transmitted to the modulation nss1mcs0 for the device with MIMO 3x3 support). The
parameter value is calculated for the last 10 s;
Link Quality
– parameter that displays the status of the link, calculated based on the number of sent
retransmit packets. The maximum value is 100% (all transmitted packets were sent on the first attempt), the
The «WDS» submenu is available only in the 'Wireless bridge' mode.
