BA-en-2058-1808_IONSTAR RX3
11
3. Installation and assembly
3.1 Assembling the discharging bar
Attach the Series IONSTAR RX3 discharging bars to the machine wall.
For easier installation we recommend using the assembly material offered
by Eltex. Fig. 3 shows the installation principle.
The profiled assembly section of the discharging bar is grooved. The slid-
ing nuts pushed into this groove serve as bolt attachments for the dis-
charging bar.
Max. bolt depth 9.5 mm
Torque 14 Nm
Caution!
Evenly space the sliding nuts across the full length.
below 1 meter total length: 2 per bar
below 2 meters total length: 3 per bar
over 2 meters total length: 4 per bar
Warning !
For safety in operation, please note the following:
• The bar must be mounted such that mechanical damage to the bar tips
is ruled out.
• When routing the cable, select the attachment points such that
mechanical damage to the cable (e.g. chafing against rotating machine
parts) is ruled out.
• In applications involving moving bars, the cable must be attached such
that there is no cable movement near the connection zone of the bar.
Fig. 3:
Assembling the
discharging bar
Z-
10
998
8
c_
3
1
2
1 aluminum profile
2 sliding nut M6
