Preferably, the installation must be done according to the following steps:
NETWORK CABLE ASSEMBLY
Provide a network cable that will connect the POE to the AMPLIMAX, with direct assembly, that is, with the same two ends. If
the cable is passed through conduits, pass it before crimping its terminals. The use of good connectors and cable is essential
(it is recommended to use shielded CAT5e cable if the installation is external), especially since the cable also conducts the
product supply. The correct assembly of this cable is essential for the proper functioning of the product and also to avoid
damaging it. For more information on cable assembly, check the Cable Assembly section in this manual. Use cable approved
by FCC, especially if the length is greater than 33 ft.
POE INSTALLATION
The POE must be installed indoors and connected to the source, computer, telephone and AMPLIMAX, as shown in the
diagram above.
INSTALLATION
Wi-Fi
or
The installation of AMPLIMAX must be done according to the simplified diagram below:
GENERAL CONNECTIONS MAP
The Sim Card
(nano) is installed
directly on the
AMPLIMAX.
100-240V
power supply
Use only a
cable of
NETWORK
RJ-45
(Ethernet)
ROUTER
SMARTPHONE
NOTEBOOK
PC OR
NOTEBOOK
POE
The product is not suitable for use in
domestic environments, as it may
cause electromagnetic interference
that requires the user to take the
necessary measures to minimize
these interferences.
To ensure better performance, it
is recommended to install
AMPLIMAX outdoors.
TABLET
