24
Setting parameters
KNX TH65-AP thermal hygrometer
• Version: 27.01.2020 • Technical changes and errors excepted.
Frost/heat protection
Set the setpoint for heating (frost protection) and/or cooling (heat protection) and ad-
just the activation delay. The delay allows you to leave the building before the controls
switch to frost/heat protection mode.
6.6.
Humidity PI control
If you activate humidity control, you can use the following settings to define control
type, setpoints, and humidification and dehumidification.
General control
KNX TH65-AP thermal hygrometer
can be used to control one- or two-stage dehu-
midification or combined humidification/dehumidification.
Start setpoint cooling in 0.1°C
valid until first call
(if the cooling regulator is being used and
only if the last retained value is "not"
retained, or retained "after power restora-
tion")
-300 … 800
Limitation of object value C(min)\r\n
in 0.1°C
-300 … 800
Limitation of object value C(max)\r\n
in 0.1°C
-300 … 800
Type of setpoint change
• Absolute value
• Increase / Decrease
Interval
(only when "increasing/decreasing")
0.1°C • 0.2°C • 0.3°C • 0.4°C • 0.5°C • 1°C •
2°C • 3°C • 4°C • 5°C
Use frost/heat protection
No • Yes
Setpoint heating in 0.1°C
(if the heating regulator is being used)
-300 … 800
Activation delay
(after opening windows)
none • 1 s … 2 h
Setpoint cooling in 0.1°C
(if the cooling regulator is being used)
-300 … 800
Activation delay
(after opening windows)
none • 1 s … 2 h
Window status before first call
Closed • Open
Use controller
No • Yes
Type of control
• One-stage dehumidification
• Two-stage dehumidification
• Humidification and dehumidification
Summary of Contents for 70184
Page 1: ...EN Installation and Adjustment KNXTH65 AP Thermo Hygrometer Item number 70184 ...
Page 2: ......
Page 35: ......
