10
Parameter settings
Temperature Sensor KNX T-UN
• Version: 27.01.2020 • Technical changes and errors excepted.
5.
Parameter settings
5.1.
Behaviour on power failure/ power
restoration
Behaviour following a failure of the bus power supply:
The device sends nothing.
Behaviour on bus restoration of power and following programming or reset:
The device sends all outputs according to their send behaviour set in the parameters
with the delays established in the "General settings" parameter block. The "Software
version" communications object is sent once after 5 seconds.
5.2.
General settings
Configure the parameter display for the
Temperature Sensor KNX T-UN
as follows:
Set the basic data transfer characteristics and activate the malfunction object as re-
quired.
5.3.
Temperature measured value
Use
Offsets
to adjust the readings to be sent.
Use parameters and objects for
the humidity sensor
No
Type of logic
Logic for temperature sensor
Use parameters and objects for
display
No
Transmission delays after power-up and programming for:
Measured values
5 s • ... • 2 h
Threshold values and switching outputs
5 s • ... • 2 h
Setpoints and actuating variable
5 s • 10 s • ... • 2 h
Logic outputs
5 s • 10 s • ... • 2 h
Maximum telegram quota
• 1 message per second
• ...
• 5 messages per second
• ...
• 20 messages per second
Use malfunction object
Yes • No
Offset in 0.1°C
-50…50; 0
Summary of Contents for KNX T-UN 130
Page 1: ...EN Installation and Adjustment KNXT UN 130 Temperature Sensor Item number 70220 ...
Page 2: ......
Page 25: ......
