Elsema Eclipse MCS, Setup And Technical Information

Page: 12 / 32

Auto Close is a feature that automatically closes the gate after a preset time has counted down to zero. The
control card has a normal Auto Close and several special Auto Close features each one having its own
countdown timers.
Elsema Pty Ltd recommends a Photoelectric Beam to be connected to the control card when any of the Auto
Close options are used.
If the Stop input is activated Auto Close is disabled for that cycle only.
Auto Close timer will not count down if the Push Button, Open or Photoelectric Beam input is held active.
Menu No. Auto Close Features
Factory
Default
Adjustable
1.1 Normal Auto Close Off 1 - 600 seconds
1.2 Auto Close with Photoelectric Trigger Off 1 - 60 seconds
1.3 Auto Close after an Open Obstruction Off 1 - 60 seconds
1.4 Auto Close after Power Restored Off 1 - 60 seconds
1.5 Normal Auto Close on Sequential Obstructions 2
Min = Off,
Max = 5
1.6 Auto Close Only when Fully Opened Off Off/On
1.7 Exit
Menu 1 – Auto Close
1.1 Normal Auto Close
The gate will close after this timer has counted down to zero.
1.2 Auto Close with Photoelectric Trigger
This Auto Close starts counting down as soon as the Photoelectric Beam has been cleared after a trigger
even if the gate is not fully open. If there is no Photoelectric Beam trigger the gate will not Auto Close.
1.3 Auto Close after an Open Obstruction
If the gate opens and hits an obstruction normally the gate will stop and remain in this position. If this
feature is enabled an obstruction will start the timer count down and at zero will close the gate.
12 Gate & Door Controller with Eclipse
®
Operating System (EOS)