Device description
elrest
Automationssysteme GmbH
e
VISIO PTE715_Windows.EN
Page: 9
ESD
Damage to Property Caused by Electrostatic Discharge (ESD)!
Indicates a potentially hazardous situation which, if not avoided, may result in damage to
property
NOTICE
Important Note!
Indicates a potential malfunction which, if not avoided, however, will not result in damage to
property.
INFORMATION
Further information
Refers to further information, which is not a substantial component of this documentation
(e.g. Internet
ST
(* comment to CoDeSys code lines *)
a := a+1;
Table 1:Symbolics
1.6
Safety instructions
For installing and operating purposes of the relevant device to your system the following safety
precautions shall be observed:
DANGER
Don’t assembly the devices under voltage!
Always switch off the power supply before assembling the device, eradicating defaults or
carrying out maintenance operations.
DANGER
Take note of the general regulations on prevention of accidents!
Take note of the relevant regulations on prevention of accidents, e.g. the regulations during
installation and commissioning of BGV A 3 "electrical installations and equipment" for
mounting, installation and eradicating defaults.
DANGER
Take note of connection in compliance with the standard!
To avoid risks of the staff and the disturbances on the device, install the data- and the supply
line conforming to standards. Take note of the correct
assignment of connections. Observe
the relevant EMC directives for your application.
ATTENTION
Replace defective or damaged device!
Replace defective or damaged device/module (e.g., in the event of deformed contacts), since
the long-term functionality of fieldbus station involved can no longer be ensured.
