ERT-A2 ALERT2 Configuration Manual
Revision 1.0
iii
There is no protection method that is completely secure. Industrial Control Systems continue to be the target
for attacks. The complexities of these attacks make it very difficult to have a complete secure system. A
defence mechanism that is effective today may not be effective tomorrow as the ways and means of cyber-
attacks constantly change. Therefore,
it’s critical that our customers remain aware of changes in cybersecurity
and continue to work to prevent any potential vulnerability of their products and systems in their
environment.
At ELPRO we are focusing on helping our customers deploy and maintain our solutions in a secure
environment. We continue to evaluate cybersecurity updates that we become aware of and provide the
necessary communication on our website as soon as possible.
Product Notices
⚠
ATTENTION
INCORRECT TERMINATION OF SUPPLY WIRES MAY CAUSE INTERNAL DAMAGE AND WILL VOID
THE WARRANTY. TO ENSURE THAT YOUR 415U-2 WIRELESS I/O AND GATEWAY ENJOYS A LONG
LIFE, CHECK THIS USER MANUAL TO VERIFY THAT ALL CONNECTIONS ARE TERMINATED
CORRECTLY BEFORE TURNING ON POWER FOR THE FIRST TIME.
Safety notices
Exposure to RF energy is an important safety consideration. The FCC has adopted a safety standard for human
exposure to radio frequency electromagnetic energy emitted by FCC regulated equipment as a result of its
actions in Docket 93-62 and OET Bulletin 65 Edition 97-01.
⚠
CAUTION
TO COMPLY WITH FCC RF EXPOSURE REQUIREMENTS IN SECTION 1.1310 OF THE FCC RULES,
ANTENNAS USED WITH THIS DEVICE MUST BE INSTALLED TO PROVIDE A SEPARATION DISTANCE
OF AT LEAST 20 CM FROM ALL PERSONS TO SATISFY RF EXPOSURE COMPLIANCE.
DO NOT OPERATE THE TRANSMITTER WHEN ANYONE IS WITHIN 20 CM OF THE ANTENNA.
ENSURE THAT THE ANTENNA IS CORRECTLY INSTALLED IN ORDER TO SATISFY THIS SAFETY
REQUIREMENT.
Avoid
•
Operating the transmitter unless all RF connectors are secure and any open connectors are properly
terminated
•
Operating the equipment near electrical blasting caps or in an explosive atmosphere
Note:
All equipment must be properly grounded for safe operations. All equipment should be serviced
only by a qualified technician.
FCC notice
Part 15.21
—
The grantee is not responsible for any changes or modifications not expressly approved by the
party responsible for compliance. Such modifications could void
the user’s authority to operate the
equipment.
Part 15.105(b)
—
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
