- 16 -
8.9. Limitation of alarms from one alarm zone (default Y)
Service Settings
→ Aux functions → Alarms limit to 3
This function limits number of alarms in one zone to three and is factory set to on (Y). Alarms
count is reset on every arming or disarming of the system. When the limit is selected to off (N)
alarm sets on every time violation is detected in the alarm zone.
8.10. Selection of menu language: Polish/English.
Service Settings
→ Aux functions → Język polski / English language
This function allows selection of the panel’s menu language using ◄► buttons.
NOTE! Change of menu language can be made also wi
th button ▲ pressed on connecting
power supply to the panel.
8.11. Beep when failure detected (default N)
Service Settings
→ Aux functions → Beeps when failure
Setting this function to yes (Y) allows control panel internal buzzer beeps on detected failures.
9. System arming signalling modes.
Service Settings
→ Arming signalling modes
This menu allows selection of alarm system arming and disarming signalling mode
. Use ▲▼
buttons to toggle
between functions and ◄► to change setting. OK button saves selection.
Exit menu any time with C button without saving selection. The following options are possible:
9.1. Remote: pulses or Remote: pulses + SMS if problem
– selecting the first option sets on
sound pulses on sirens only (**). Selecting second option allows sound pulses on sirens and
SMS notification if any problem occurs (*).
9.2. SMS: SMS or SMS: SMS if problem
– selecting first option a return SMS is send
on arming SMS. Selecting second option sets on sound pulses (**), while SMS notification is
received only if problem occurs (*).
9.3. CLIP: SMS or CLIP: pulses + SMS if problem
– selecting first option a return SMS is re-
ceived on CLIP arming. Selecting second option sets on sound pulses (**), while SMS notifi-
cation is received only if problem occurs (*).
9.4. Pulses on WSS - setting on/off arming sound pulses on wireless Elmes WSS siren.
9.5. Pulses on S1 , Pulses on S2 , Pulses on O1 , Pulses on internal buzzer
– setting on
arming signalling sound pulses on S1, S2, O1 and buzzer. Signalling may be set on for all
outputs independently.
9.6. Chime and countdown on S1
↔ …on S2 ↔ . …on O1 ↔ …on internal buzzer – setting
on sound pulses on Chime zone violation and arming countdown pulses on one of outputs S1,
S2, O1 or internal buzzer.
9.7. No pulses at night or Pulses on S2 at night or
…on O1 at night or …on buzzer – setting
on night arming signalling sound pulses on S2, O1 or internal buzzer.
(*) While system arming violation of supervised zone may occur. Depending on whether the
zone is “bypass” type (see pt. 3.1.g), the system will arm and SMS notification will be received
informing of the bypassed zone/s or, if
the zone is not “bypass” type, the system will not arm
and SMS notification will be received with information of violated zone/s.
(**) In order to obtain sound pulses functionality, a sound siren must be connected to one of
S1, S2 or O1 outputs and sound signalling set on at that output (pt. 9.5). Internal buzzer may
also be used for the purpose.
10. System Status
10.1. Service Settings
→ Status → GSM signal level
Horizontal bar graph of mobile signal strength received by control panel GSM module is dis-
played. Strength level weaker than indicated by four bars only is insufficient for proper GSM
operation and control panel placement should be changed.
