•
Open the base station.
Press lightly on the 4 catches on the back of the base station. You can see
the base circuit board after you remove the top cover.
•
Loosen the fixing screws for the circuit board and remove it. You can then
attach the bottom half of the enclosure to the wall using the anchors and
screws supplied with the unit.
Only install the base station with the terminals facing the bottom (see Figure 1), as
this ensures optimal coverage.
•
Route the installation cable through the bottom into the enclosure. Do this
by breaking out the prepunched cover piece. Screw the enclosed plastic
web into place to fix the installation cable in place (strain relief), as shown
in Figure 1.
•
Connect the installation cable for the analog connections to the 16-pin
terminal strip (see »Base station terminals«).
•
Screw the circuit board securely back to the bottom of the housing, ensu-
ring that the wires for the installation cable are not pinched.
•
Replace the top cover and press down on it lightly until the catches lock in
place again.
•
Plug the connector for the power unit into the jack (see Figure 1). Only use
the plug-in power unit supplied in the package with the base station (ID
number 2430).
•
Plug the power unit into the 230V~ outlet.
3
Fig. 1
13
G:\_elmeg\DECT300\Basis\V1\Ger-UK\de_uk-d300-mt-10x1.vp
Dienstag, 12. Februar 2002 11:00:14
Farbprofil: Generic CMYK printer profile - None
Komposit Standardbildschirm
